Woodstock W1819/W1820 manual See =`li\

Df[\cN(/(0&N(/)'D]^%J`eZ\()&('

,% Insert the lip of the lower part of the dust port into the cabinet and tighten the thumb knob to secure

(see =`^li\()).

Thumb Knob

-%Remove the M8-1.25 x 30 cap screws, 8mm flat washers, and 8mm lock washers from the ends of the main table.

.% Inspect the extension wings and main table mating surfaces for burrs or foreign materials that may inhibit assembly.

=`^li\()% Dust port installed.

The mating edges of the wings and the table must
be clean, smooth, and flat. Use a wire brush or file
if necessary to clean up the edges. This step will
ensure that the wings mount properly to the main
table.	x4

/% While a helper holds the wings in place, attach each extension wing to the main table with the four M8-1.25 x 30 cap screws, 8mm lock washers, and 8mm flat washers removed in Jk\g- (see =`^li\ (*).

J<KLG

0% Place the straightedge across the extension wings and main table to make sure that the combined table surface is flush and flat.

—If the combined table surface is flat, skip to the next step.

—If the outside end of the extension wing tilts down, use a strip of masking tape along the bottom edge of the main table to shim the extension wing up (=`^li\(+).

—If the outside end of the extension wing tilts up, use a strip of masking tape along the top edge of the main table to shim the extension wing down (=`^li\(,).

Efk\18]k\ii\$`ejkXcc`e^n`e^j#i\dfm\Xcc\oZ\jj dXjb`e^kXg\n`k_XiXqfiYcX[\%

=`^li\(*% Extension wings installed.

=`^li\(+% Masking tape location for tilting

the extension wing up.

=`^li\(,% Masking tape location for adjusting the extension wing down.

-23-