Woodstock W1819/W1820 manual ok\ej`feKXYc

Df[\cN(/(0&N(/)'D]^%J`eZ\()&('

Efk\1 9\]fi\k`^_k\e`e^k_\]Xjk\e\ij#Z_\ZbkfdXb\jli\ k_\kfg\[^\f]k_\i\XiiX`c`j]clj_n`k_k_\cfn\jk\[^\ f] Yfk_ K$jcfkj j\\ =`^li\)' # jf k_\ d`k\i ^Xl^\ n`cc jc`[\jdffk_cpn_\e`ejkXcc\[cXk\i%

N(/(0<ok\ej`feKXYc\

(% Install the extension table between the front and rear rails with the four M6-1 x 16 hex bolts, eight 6mm flat washers, four 6mm lock washers, and four M6-1 hex nuts, as shown in =`^li\)(.

=`^li\)'% Verifying rear rail is flush with

bottom of T-slot.

)% Using a long straightedge, adjust the extension table
so it is flat (both flush and parallel) with the main
	=`^li\ )(. Model W1819 extension table
table and extension wings (=`^li\))), then tighten
	installed.
the fasteners.

J<KLG

N(/)'<ok\ej`feKXYc\

(% Remove the six M6-1 x 16 hex bolts, (12) 6mm flat washers, six 6mm lock washers, and six M6-1 hex nuts from the extension table.

)% While an assistant holds the extension table between the front and rear rails, fasten the extension table to the rails with the fasteners removed in Jk\g(.

*% Thread the feet into the legs with the two M8-1.25 x 60 hex bolts, place the legs under the table, and thread the feet out until the top of each leg is against the underside corner of the table.

+% Use the four M8-1.25 x 20 cap screws, 8mm lock washers, 8mm flat washers, and M8-1.25 hex nuts to secure the legs to the end of the extension table, as shown in =`^li\)*.

-25-

=`^li\))% Adjusting Model W1819

extension table flush with wing and table.

x4

Foot

=`^li\)*% Model W1820 extension table

installed.