![](/images/new-backgrounds/1036396/3639647x1.webp)
Page: 24 |
|
|
| Model BXAUDIO4X4 | |
30 | 34 | 36 | 37 | 31 | |
32 |
|
|
|
|
|
33 |
|
|
|
|
|
35 |
|
|
|
| 38 |
42 |
|
|
|
| 39 |
43 |
|
|
|
| 40 |
44 |
|
|
|
| 41 |
|
|
|
| ||
|
|
|
|
| 42 |
Programming Button Layout
PROGRAMMING SOURCE POWER MANAGEMENT
With the ability to turn the system ON and OFF from more than one location, the BXAUDIO4X4 Controller needs to know when the different sources are ON or OFF and be able to know when to send or not send power commands to keep the sources in sync with the system. The BXAUDIO4X4 Controller features a Current Sense input for each of the four Source Inputs. The optional CSM1 Current Sense Module is required for this feature.
This eliminates the need for programming Power Macro’s under each Keypads Source button or the need for discrete codes to assure the source components are in the proper Power State (toggle Power Commands can be used).
To program Power Management, complete the following procedure:
Note: The following procedure assumes the CSM1 Current Sense Module is in use and has been calibrated properly.
1.Enable PROGRAM MODE [11] (Make sure an LCKP4 Keypad is plugged into the Zone 1 Keypad port and the Keypad is ON).
2.Press the PROGRAM KEYPAD button [2] on the front of the BXAUDIO4X4.
a.Confirm the PROGRAM KEYPAD LED [11] is illuminated GREEN.
3.Press the POWER MANAGEMENT button once on the front of the BXAUDIO4X4 Controller [3]
a.The POWER MANAGEMENT LED [12] will turn GREEN signaling the system is in POWER ON programming mode.
4.Press the proper SOURCE BUTTON on the LC4KP Keypad for the Power Management codes to be programmed. Note: the ZONE LED’s 1 thru 4 [15] now will represent SOURCES 1 thru 4.
a.The STATUS LED will turn GREEN [14].
5.Aim the Manufactures Source Remote at the IR Learning eye on the front of the BXAUDIO4X4 [5].
6.Press and Release the corresponding POWER button on the devices remote.
Note: If discrete IR Codes are available for POWER ON and OFF teach the POWER ON command at this time otherwise use the single toggle Power Command.
7.If the code was learned correctly:
a.The STATUS LED [14] will turn OFF
b.PROGRAM KEYPAD LED [11] will remain GREEN
c.The Corresponding Source (Zone) LED [15] will Turn GREEN indicating a Power ON Macro was successfully recorded.
8.Press the POWER MANAGEMENT button once on the front of the BXAUDIO4X4 Controller [3]
a.The POWER MANAGEMENT LED [12] will turn RED signaling the system is in POWER OFF programming mode.
Note: If the POWER MANAGEMENT LED is still GREEN, press the button again until it changes to RED.
© 2005 Xantech Corporation