CONTROLLER/AMPLIFIER Features, Central Processor

Model BXAUDIO4X4

Page: 5

CONTROLLER/AMPLIFIER FEATURES

•Four Audio Source Inputs

•Current sensing (>20mA-<10A) for each input for power management of common source components and using the optional CSM1 Current Sense Module

•Four source specific IR emitter ports and one common IR output.

•Internal memory (96 Kbytes non-volatile flash) for storing IR codes.

•Programmable via EZProgramming™

•Recognizes Xantech RC68+ Commands for wireless IR Zone and Source control (RC68+ Group Code 48)

•Outputs single IR commands or IR sequences.

•Sends "busy" signal to keypads when system is active.

•IR learning eye on front panel of Controller/Amplifier used for source component macro programming

•DB-9 RS232 Serial port for programming, expansion and upgrading firmware (Future Proof).

•Also available in 230 VAC / 50 Hz. (Part No. BXAUDIO4X4-77SYS)

•Each zone has 1 RJ45 connector for BXAUDIO4X4 keypad, 1 speaker-pair terminal and a 12VDC status output.

•Party Mode: Multiple zones can be linked to behave as one zone.

•25 Watts per channel (rated at 8-Ohm; 4-Ohm safe).

•Frequency response: 12 Hz to 55KHz (±3dB)

•THD: <0.08%.

•Signal-to-noise ratio: > 96dB A-weighted

•No PC Required.

•Front Panel programming of all IR codes for control of source components.

•Program sequences of up to 40 IR codes per button.

•Incorporate delays in sequences to allow for amplifier power-up, light dimming, screen drop, drape closure, etc.

•Intelligent Power Management: Automatically keeps Source Components in sync with Zone power status (Requires CSM1 Current Sense Module).

•Flush-mount, snap-in wall unit. Fits into standard Dual-Gang J-Box with universal wall mounting plate.

•16 buttons (4 source select, 11 function, 1 power).

•Backlit buttons.

•Bi-colored Status LED for power and status.

•Broadband IR receiver (30KHz to 100KHz).

•Connects to BXAUDIO4X4 Controller/Amplifier via CAT5 cable with RJ45 connectors.

•Two RJ45 connectors allow two keypads per zone.