![](/images/new-backgrounds/1036396/3639661x1.webp)
Model BXAUDIO4X4 | Page: 31 |
SECTION 8.0: OPERATING INSTRUCTIONS
With all system components connected and the BXAUDIO4X4 Controller and Keypads programmed, The system is ready for use.
5
13
1
6
7
8
2 | 3 |
| 2 | 3 | 4 |
|
| 5 |
|
|
|
|
| 1 |
|
|
|
| 14 | 11 |
|
|
|
|
| 6 |
|
| 9 |
| 4 | 7 |
|
| 10 |
|
|
|
|
|
912
10
11
12
LC4KP Keypad Button Layout | MRCREM Remote Button |
| Layout |
Zone Control
Controlling the BXAUDIO System can be done in two ways within the Zone; either by pressing buttons on the LC4KP Keypad or by using the MRCREM Zone Companion Remote. The MRCREM comes
It is basically a keypad in your hands.
MRCREM Remote:
Point the MRCREM at the LC4KP’s IR Receiver [14], press any of the corresponding numbered buttons on the remote to trigger the Macro stored under the BXAUDIO’s LC4KP Keypad Button.
Note: Source buttons labeled 5 thru 8, Memory Preset buttons M1 thru M4 and the ENTER button are non- active when used with the BXAUDIO4X4.
To Control the Zone with the LC4KP Keypad and/or the MRCREM Remote, follow the steps below:
1.Press the ”POWER” button on any keypad or MRCREM remote [5]. The BXAUDIO4X4 Controller will turn ON. If Power Management has been enabled, source components will turn on also.
2.Select a Source [Buttons 1 thru 4]. Operate the source with the appropriate commands (PLAY STOP PAUSE etc…) etc)
3.Adjust the VOLUME to a suitable listening level using the Volume UP and Volume Down Buttons [Buttons 9 & 10]
4.MUTE and
5.Change Sources [Buttons 1 thru 4].
6.Press “POWER” again and the zone will turn OFF [5]. If power management has been enabled, when the last zone turns OFF, the source components will turn OFF as well after a 10 second delay.
© 2005 Xantech Corporation