Model BXAUDIO4X4 | Page: 17 |
| Primary Keypad |
| Secondary Keypad | ||||
Application | Secondary | Zone | Sensor | Secondary | Zone | Sensor | |
Keypad | Termination | Enable | Keypad | Termination | Enable | ||
| |||||||
One keypad in Zone with IR | OFF | ON | ON |
|
|
| |
Sensor enabled |
|
|
| ||||
|
|
|
|
|
| ||
Two Keypads in Zone with IR | OFF | OFF | ON | ON | ON | ON | |
Sensors enabled | |||||||
|
|
|
|
|
| ||
One Keypad and one separate | OFF | ON | OFF |
|
|
| |
IR Receiver in Zone |
|
|
| ||||
|
|
|
|
|
| ||
Two Keypads and two separate | OFF | OFF | OFF | ON | ON | OFF | |
IR Receivers in Zone (Sub- | |||||||
Zone) |
|
|
|
|
|
|
Table 1 – LC4KP Keypad Jumper Configurations
Multiple Keypad Connections
1.For a second keypad in the same zone, terminate the CAT5 cable in the same way as shown in Figure 10.
2.Connect the CAT5 coming from the BXAUDIO4X4 Controller to the “CONTROLLER” jack on the Primary Keypad. Plug a CAT5 cable into the “EXPANSION” jack on the Primary Keypad and connect it to the “CONTROLLER” jack on the Secondary Keypad. Set the jumpers according to the above Table 1.
3.When adding an IR receiver in the zone, set the jumpers according to the above table and connect the cables as shown in Figure 10.
© 2005 Xantech Corporation