Link 2000 Remote Control Panel

 

 

 

 

 

 

 

Table 3-2DIP switch function and position summary

 

Feature

 

Switch Number

 

 

Set Point

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Off

 

 

Enable: Charger on when

 

 

 

 

 

 

AC connected.*

 

Idle Sensitivity

 

5

6

 

 

 

 

 

 

 

 

 

 

 

 

 

 

On

On

 

Idle disabled

 

 

 

Off

On

 

15 watts

 

 

 

 

On

Off

 

6 watts

 

 

 

 

Off

Off

 

4 watts*

 

 

Power Sharing

 

7

8

 

 

 

 

 

 

 

 

 

 

 

 

 

 

On

On

 

2 amps

 

 

 

Off

On

 

5 amps

 

 

 

 

On

Off

 

10 amps

 

 

 

 

Off

Off

 

15 amps*

 

 

 

 

 

 

 

 

 

*Default setting.

**Refer to voltages under “Battery Charger Voltage Settings”.

Remote Control Wiring

The remote control panel is supplied with 7.62 m or 15.24 m of RJ11 remote cable. The cable supplied may have 6 conductors; however, only 4 conductors are required. You may buy standard 4-conductor telephone cable and run up to

15.24 m if desired. Use only a single length of telephone wire—do not splice.

Remote Power Consumption

Table 3-3System current consumption versus idle mode

Idle Mode

With Remote

Without Remote

 

 

 

Normal Idle

181 mA

120 mA

Idle Circuit Disabled

496 mA

n/a

Unit Shut Off

16 mA

7 mA

 

 

 

Link 2000 Remote Control Panel

The Link 2000 and 2000R offer increased monitoring and control options. In addition to providing inverter/charger control, the Link 2000 enables precision monitoring of DC voltage, current, and amp hours for two battery banks.

The Link 2000R adds the ability to control an engine driven alternator. This precision regulator transforms an alternator into a 3 stage battery charging system like the charger in the Freedom 10.

If a Link 2000 or 2000R remote is being used to control the inverter/charger, refer to the Link manual for setup and control information.

975-0251-01-01

3–7

Page 45
Image 45
Xantrex Technology 10 owner manual Link 2000 Remote Control Panel, Remote Power Consumption