Configuration
Installing the ICA Software: ICAP
The Inverter Communications Adapter software program (ICAP) is included on the CD in the ICA package. It allows a personal computer to operate as a virtual control panel for up to eight Sine Wave Plus Inverter/Chargers.
For other computer platforms, See “Setting Up a Modem Connection” on page 21.
Select one of the following methods to install the software:
•Use Autorun (must be enabled on your CDROM drive).
•Manual Start (assumes that Autorun is not enabled on your CDROM drive).
•Use a Command prompt to initiate the installation program.
Important: Software levels shown in these illustrations may not represent the most current version.
Starting the Setup Program Using Autorun
To install the software with Autorun enabled on your CDROM drive:
1.Insert the CD into your computer’s CDROM drive. If autorun has not been disabled for the CDROM in your computer, the Welcome screen shown in Figure
Figure 2-1 ICAP Welcome Screen
14 |
