Xerox 4215/MRP manual Image area, Fonts, Downloading fonts

HP LASERJET EMULATION MODE

Image area

For compatibility with Hewlett-Packard printers, a border area on the outside edges of the paper is unavailable for printing when in HP LaserJet Emulation mode. This space is approximately 0.17 inches (4.2 mm) on each side, as shown in figure 2-1. The shaded area shows the image area.

Figure 2-1. Image

For envelopes with HP PCL, there is a border area of approximately 0.27 inches (7 mm) on the edge toward the front of the printer, as well as 0.17 inches (4.2 mm) along the other three edges, as shown in figure 2-2.

Figure 2-2.Envelope and post card edge deletion area

Feed edge

Deletion areas

Feed

Deletion areas

Post card Envelope

Fonts

The printer implements the internal font set of the HP LaserJet IIISi. For information on fonts, refer to the Xerox MRP Family 4220/MRP, 4230/MRP Operator Guide.

Downloading fonts

In addition to the supported fonts listed in the operator guide, the printer can download other bitmap and scalable fonts. Scalable Intellifont soft fonts and TrueType fonts are supported.

Downloadable fonts that are made permanent (E*c5F) or temporary (E*c1F) are not listed on the Font Report, and cannot be stored on the optional hard disk. Permanent fonts remain in memory until you power off the printer or delete them.

NNote: If you are running a 4220 product using a software version lower than V1.54, PCL fonts cannot be stored on flash ROM.

XEROX MRP FAMILY PCL 5 AND POSTSCRIPT PRINTER LANGUAGE REFERENCE 2-7