3.3 CALIBRATING THE UW/W 100
3.3.1Calibrating the rear tensioning system
Parts and Tools needed |
|
| |
|
|
|
|
|
| Included in kit | |
No. | Description |
| Quantity |
1 | Synthetic paper strip |
| 1 |
2 | Hexagon wrench 2,5 mm |
| 1 |
3 | Hexagon wrench 3 mm |
| 1 |
4 | Hexagon wrench 4 mm |
| 1 |
|
| NOT included in kit | |
No. | Description |
| Quantity |
1 | Tape |
| 1 |
2 | Pencil |
| 1 |
3.3.1.1Checking the calibration
The procedure below describes the calibration check of the rear tensioning system. The method to check the front tensioning system is the same. However, the front and rear tensioning bars use different bars to complete the calibration.
Procedure :
PART 1 : PREPARING THE SYNTHETIC PAPER STRIP
Step 1 : Put the pressure rollers in the up position.
Step 2 : Go to the back of the machine.
Step 3 : Create a loop with the synthetic paper strip around the upper bar of the rear tension system at the left side when standing at the back of the printer.
FRONT | REAR |
