Parameters of the Device Settings Tab (continued)
Output Protocol – Specifies the output format. It is recommended that you leave this setting at the default of ASCII.
Add Euro Currency Symbol to PostScript Fonts – This setting adds the euro currency symbol to most PostScript fonts.
Job Timeout - Leave this setting at the default of 0 seconds. Wait Timeout Leave this setting at the default of 300 seconds.
Minimum Font Size to Download as Outline - Specifies the minimum font size (in pixels) for which the PostScript driver will download TrueType fonts as scaleable outline (Type 1) fonts. A font smaller than the minimum setting will be downloaded as a bitmap (Type 3/Type 32) font. This option essentially lets you fine tune the Automatic setting for the TrueType Font Download option on the Advanced tab in the Document Properties dialog box (available from “File,” “Print,” “Properties” in your desktop application).
Maximum Font Size to Download as Bitmap - Specifies the maximum font size (in pixels) for which the PostScript driver will download TrueType fonts as bitmap (Type 3/Type 32) fonts. A font larger than the maximum setting will be downloaded as a scaleable outline (Type 1) font. This option lets you fine tune the Automatic setting or override the bitmap (Type 3/Type 32) setting for the TrueType Font Download option on the Advanced tab in the Document Properties dialog box (available from “File,” “Print,” “Properties” in your desktop application).
AccXES Settings
About AccXES
Select Finisher - Select this option, then click the "Select Finisher" button to open and import a Finisher (.fin) file into the driver. This file informs the driver of available Finishing Device options to display under
the Finisher group of the Job Tab of the Document Properties Dialog.
Note: Make sure that the Finisher file that you select matches the capabilities of the Finisher (folder) that you purchased. If necessary, you can create your own Finisher file using the XESFin.exe program and
instructions available on the Internet at www.xes.com. After downloading the executable file to your workstation, open a command prompt on your desktop and provide the path to the "xesfin.exe" file on your workstation. A sample entry might be: C:\Temp>xesfin.exe (assuming the executable file was downloaded to your Temp directory). Press Enter. At the command prompt, create a command like the example shown on screen. With the finishing device attached to your printer's Controller and powered on, press Enter to create your own finisher file. You can then use the Select Finisher button as described above to import the finisher file into this driver.
Display Units - Select this option to enable you to choose "display units" in inches or millimeters for all applicable,
Firmware Revision - Select the version of AccXES firmware currently installed in your printer’s Controller for the correct display of firmware- supported driver options.
XES Synergix 8825/8830/8850/8855 Windows NT 4.0 PostScript Print Driver User Guide | 9 |
