Introduction
Purpose of this Guide
The purpose of this Guide is to assist you with instructions for installing a PostScript Print Driver, adjusting the Print Driver’s settings to meet your needs, printing with the Print Driver, and removing the driver when it is no longer needed.
Electronic copies of this Guide are available on the Internet at www.xes.com.
Basic Requirements
A Workstation running Windows NT 4.0 with Service Pack 3, or higher, installed.
A Working Knowledge of your Workstation’s Operating System.
Appropriate Cabling connecting your workstation to the network or directly to the printer's AccXES Controller.
Appropriate protocols and ports enabled on both the printer and workstation, with a connection established through the network or directly between the printer and your workstation.
How to Use this Guide
1.Read “Before You Start” for valuable information on checking the status of your communication protocols and creating a new printer port for use with the PostScript Driver.
2.Install the driver on your workstation as stated in the Driver Installation section of this Guide.
3.Configure the driver settings to meet your needs as stated in the Driver Configuration section of this Guide.
4.Click OK on the Print Screen to print your job.
5.If you no longer need the driver, remove the driver as stated in the Removing the Driver section of this Guide.
XES Synergix 8825/8830/8850/8855 Windows NT 4.0 PostScript Print Driver User Guide | 1 |
