Xerox 96/4635/180 IPS manual Fuser Lubricant

FUSER LUBRICANT

Warning: If any￿fuser agent spills on the floor, remove it

! immediately. Fuser agent spills make the floor slippery. Use of Xerox Film Remover (isopropyl alcohol) is recommended to clean up spills.

Caution: The fuser reservoir has an anti-splash seal. Do not push the fuser agent bottle into the reservoir with excessive force, as this can damage the seal.

7. Replace the reservoir cap by turning it clockwise and push the fuser agent reservoir in until it stops.

8. Push the fuser drawer in until it latches in place.

9.Dispose of the dropcloth and any empty agent bottles in a trash receptacle. If there is any agent left in the bottle, cap the bottle and store it for future use.

10.Remove and dispose of the gloves in a trash receptacle, being careful not to let any residue come in contact with your skin.

11.Close the printer doors.

Note: The fuser agent message disappears after the printer prints between 32 and 40 sheets. Since the sheets must be processed continuously, you may want to run 45 test pages in order to clear the message from the system (unless the current print job contains at least 40 pages).

12. Wash your hands to remove any fuser agent.

3-4 XEROX DOCUPRINT 96/4635/180 IPS GUIDE TO PERFORMING ROUTINE MAINTENANCE