Specifying Timeout
Xerox LS 3270
- 16 -
The new setup must be saved in the NVRAM3 with the following
command ("%" is the ESC Character):
%X1
The FSL string above was split up into several lines for reasons of
clarification to simplify the explanation of the different functions.
Below is an example where the FSL string is typed in one line.
Example:
&&??%%Y100,30,1B,45%%X1
The FSL string above has the following effect:
•Defines % as ESC character
•Sets timeout to 30 seconds
•Send 1B 45 HEX before the next data transmission.
•Saves setup in the NVRAM.
NOTE:
FSL Y100 works on the port it is sent to. If it is sent
to the parallel input port, the string containing the
Function Y100 programming will be printed when it
is sent to the Xerox LS 3270. See Chapter 6, FSL
Setup via Xerox LS 3270 Parallel Port
3NVRAM = Non-volatile RAM