Introduction
Xerox LS 3270
Changing the Driver
To change from PCL to FSL driver or vice versa, first of all the rotary switch has to be in position T at power on. The current printer driver will be indicated on a printout. The actual selection of printer driver is then made by turning the rotary switch to position A (PCL) or B (FSL). The new position will also be indicated on a second printout. When the correct position is obtained, turn the rotary switch away from the A, B or T positions (any other position will do). The new driver is now active.
1.2. Xerox LS 3270 Features
The Xerox LS 3270 protocol converter gives you the following fea- tures:
∙IBM 3287, 32681 and 4214 emulations
∙Support of the SCS (LU1) and 3270 data stream (LU0 or LU3) modes including FMH data streams as required by the host system.
∙All IBM RPQs
∙Parallel output in PCL mode
∙Up to 8 user strings of variable length can be transmit ted to the printer from the Xerox LS 3270 - automatically at power on and before and after Local Copy from the host system.
∙Automatic input sharing between Coax and Centronics input ports.
∙Coax FSL setup via share port
∙Flash prom allowing downloading of new firmware via the coax or the centronics port.
∙Support of ida PSS
∙Autoconfiguration (PCL only)
13268 = factory default
- 5 -
