Emerson manual Introduction, Chapter, Overview, 1 Key Features of the MVME2500

Chapter 1

Introduction

1.1Overview

The MVME2500 is a VMEbus board based on the Freescale QorlQ P2010 (single-core) or P2020 (dual-core) processor. It has a 6U form-factor and has an expansion slot for an optional PCI Mezzanine Card (PMC) or PCI eXpress Mezzanine Card (XMC). It comes with either 1 GB or 2 GB of DDR3 SDRAM, and is offered with either IEEE 1101.10 compliant or SCANBE ejector handles.

The front panel I/O configuration consists of two RJ45 10/100/1000BASE-T Ethernet ports, a

USB 2.0 port, a Micro DB9 RS-232 serial console port, and a reset/abort switch. It also has an

LED to signal board failure and another LED that can be configured in the LED register.

The rear I/O includes support for VMEbus (Legacy VME, VME 64, VME64x, and 2eSST), rear

PMC/XMC I/O, RTM I/O (through VME P2), two 10/100/1000BASE-T Ethernet, four UART, and

RTM I2C/Presence/Power. See the table below for a summary of the features of the

MVME2500.

Table 1-1 Key Features of the MVME2500

Function	Features
Processor		Freescale QorIQ P2010 (single-core) or P2020 (dual-core)
	 800 MHz or 1000 MHz core frequency
	 512 KB L2 cache
	 Three 10/100/1000 Mbps enhanced three-speed Ethernet
		controllers (eTSECs)
	 Two PCI-E 1.0a x1 interface controllers
	 One PCI-E 1.0a x2 interface controller
		USB 2.0 interface
	 Enhanced secure digital host controller
	 DDR3 memory controller at 800 MT/s
	 SPI interface (four chip selects, but only two are used on the
		board)
	 Enhanced local bus controller
		UART
		Two I2C interfaces
		Programmable interrupt controller
Memory	1 GB or 2 GB DDR3 soldered chip memory without ECC

MVME2500 Installation and Use (6806800L01H) 19