Installation
Xerox LS 3270
- 10 -
Printer Cable:
The Xerox LS 3270 does not necessarily have to be plugged
directly into the Centronics Input Port of your printer. An extention
Centronics cable can be ordered for distance connection between
the Xerox LS 3270 and your printer. This kit also contains a velcro
tape to enable mounting on the side of a printer.
Order no. 999 020 030
2.2.2 Installation Procedure
Below follows the procedure for installing the Xerox LS 3270:
1. Make sure the printer power is turned OFF.
2. Plug the Centronics Output Port of the Xerox LS 3270 into
the Centronics Input port of the printer and lock it with the
bail locks.
3. Check that the rotary switch on the Xerox LS 3270 is in the
correct position for the printer driver needed:
Position A for PCL (default)
Position B for FSL
If you need to make changes to the printer driver, see
section 1.1.1, PCL or FSL output Driver, “Changing the
Driver”, for details on how to do this.
4. Connect the coax cable to the Xerox LS 3270.
5. Power ON the printer. The CU and PAR LEDs of the Xerox
LS 3270 will turn on if the power is sufficient (for location of
CU and PAR LEDs, see figure 2-1 in Section 2.1 Knowing
the Front Panel).
6. Check power and signal connection. If po wer is sufficient
and a coax connection exists between the Xerox LS 3270
and a controller, the green CU LED will stay ON. If the CU
and PAR LEDs were not turned on at power on, you must
add an external power supply to the Xerox LS 3270.
5. Send a job from the host system and check the printout.
Note that the system printer emulation must match the
Xerox LS 3270 printer driver. If not, change the printer driver