Continued
■When selecting the “WIDE” (Dolby Virtual Speaker Wide) mode 2 SP : When using 2 front speakers only.
3 SP : When using 2 front and center speakers
4 SP : When using 2 front and 2 surround speakers.
5 SP : When using 2 front, center and 2 surround speakers.
■Note: When the speakers are set to “N” (None), the corresponding speaker layouts cannot be selected.
[Dolby Headphone Parameters]
■When selecting the “DH 1”, “DH 2”, “DH 3” (Dolby Headphone 1,2,3) mode MOVIE : This provides the surround effect suitable for movie sources.
MSC 1 : This provides the surround effect suitable for music sources.
MSC 2 : This provides less surround effect compared to Music 1 mode.
■Note : You can select the listening mode only when playing analog stereo, PCM 2 channel or Dolby Digital 2 channel source.
4. Repeat the above steps 2 and 3 to adjust other parameters
Adjusting each channel level with test tone
• The volume level of each channel can be adjusted easily with the test tone function.
■Note : When the SPEAKER button is set to off or it is in the stereo mode, etc., the test tone function does not work.
ENGLISH
1. Enter the test tone mode.
•The test tone will be heard from the speaker of each channel for 2 seconds as follows:
→FL → C → FR → SR
Front Left Center Front Right Surround Right
SW ← SL ( ← SB) or ( ← BL ← BR) ←
Subwoofer Surround Left Surround Back Surr.Back Left Surr.Back Right
•When the speaker setting is "N” (None or No), the test tone of the corresponding channel is not available.
•( ) : Possible depending on whether the surround back channel is set to "2c" (2ch) or "1c" (1ch).
2. At each channel, adjust the level as desired until the
sound level of each speaker is heard to be equally loud.
•You can select the desired channel with pressing the CONTROL UP(▲)/DOWN(▼) buttons or the CURSOR UP(▲)/DOWN(▼) buttons.
3. Cancel the test tone function.
23
