ENGLISH
Continued
■About the first listening position
The first listening position is the point where a listener sits most often or the listening position when only one person is listening. Measurements start from this point.
•If you want to personalize your speaker setup and channel level setup by making the settings manually, perform "When selecting the SPEAKER CONFIGURATION" on page 44, "When selecting the SPEAKER DISTANCE" on page 45, "When selecting the SPEAKER CROSSOVER" on page 46, "Adjusting each channel level with test tone" on page 23 and "Adjusting the current channel level" on page 24.
•After the auto setup has been completed, set the room EQ mode as desired. (For details, refer to "When selecting the ROOM EQ" on page 47.)
■Preparations
①Check that the speakers are securely connected to this receiver.
•If your subwoofer has adjustable volume and crossover frequency, set the volume halfway and set the crossover frequency to the maximum or the low pass filter off.
②Connect the supplied microphone to the SETUP MIC jack on the front panel.(For details, refer to "SETUP MIC JACK" on page 12.)
■Notes :
•Because the microphone for Auto Setup is designed for use with this receiver, to use the auto setup function, do not use a microphone other than the one supplied with this receiver.
•After you have completed the auto setup procedure, disconnect the microphone.
1. Place the microphone on a flat level surface at the first main listening position.
•If possible, use a tripod, etc. to attach the microphone at the same height as your ears would be when you are seated in your listening position.
•Ensure there are no obstacles between the speakers and the microphone.
2.Press the CURSOR UP(▲)/DOWN(▼) buttons to select the “AUTO SET” , then press the ENTER button.
3. Press the CURSOR UP(▲)/DOWN(▼) buttons to select the “START”, then press the ENTER button
When measurements at first position have been completed.
•Each time the CURSOR UP(▲)/DOWN(▼) buttons are pressed, “START” or “RETURN” is selected.
•Loud test tones are output from each speaker and then if measurements at the first position have been completed, "CONTINUE" will be displayed.
42
