SETTING THE CLOCK
1
DISPLAY
2
TUNING
HOUR | MINUTE |
MEMORY | FM MODE |
| Changes. |
TIME ADJ | CLEAR |
3
TUNING
HOUR | MINUTE |
MEMORY | FM MODE |
| Changes. |
TIME ADJ | CLEAR |
4
TUNING
HOUR MINUTE
MEMORY | FM MODE |
TIME ADJ | CLEAR |
Europe model uses an “00:00”
1 While the station frequency indicator on the tuner or the “ON TIME” indicator is lit, press the DISPLAY button to display the time.
2 While pressing the TIME ADJUST button, press the HOUR button and set the hour.
*Press the HOUR button once to advance the time by 1 hour. Press and hold to advance continuously.
3 While pressing the TIME ADJUST button, press the MINUTE button and set the desired time.
*Press the MINUTE button once to advance the time by 1 minute. Press and hold to advance continuously.
*The hour setting will not advance even if minutes advance from “59” to “00”.
4 Release the TIME ADJUST button to start the clock at the correct time.
*The clock starts operating from “0” seconds. (Seconds are not displayed.)
In the event of a power failure or when the AC supply lead is disconnected.The clock display will go out.
When the AC power supply is resumed, the clock display will flash on and off to indicate that the time must be reset.
COMPACT DISC OPERATION
Care of compact discs
Compact discs are fairly resistant to damage, however mistracking can occur due to an accumulation of dirt on the disc surface.
Follow the guidelines below for maximum enjoyment from your CD collection and player.
• | Do not write on either side of the disc, particularly the non- |
| label side. Signals are read from the |
• | not mark this surface. |
Keep your discs away from direct sunlight, heat and | |
• | excessive moisture. |
Always hold the CDs by the edges. Fingerprints, dirt or | |
| water on the CDs can cause noise or mistracking. If a CD |
| is dirty or does not play properly, clean it with a soft, dry |
| cloth, wiping straight out from the centre, along the radius. |