Yamaha CC-5 Recording from the CD player (CD, Synchronized Recording System), RECORDING, 6,2, 6,2, Press the stop, one side, or to, to record on only, To stop recording

RECORDING

•When recording important selections, be sure to make a preliminary test to ensure that the desired material is being properly recorded.

•The automatic recording level control circuit automatically controls the level of the input signal used for recording.

•Adjusting the VOLUME, BALANCE, TREBLE and BASS controls and selecting any SOUND PROCESSOR program have no effect on the recorded sound.

								Recording from the CD player (CD
					1		6,2	Synchronized Recording System)
								1 Select the CD position and load the CD to be recorded.
								2 Load a tape into the tape “b” cassette compartment.
								* Wind past the beginning part of the tape on which
								recording can not be performed.
								3 When recording with the Dolby NR system, set the
								DOLBY NR switch to B or C; if not, set it to OFF.
								* For selection of the Dolby B or C position, refer to the
								“Dolby B and C Type Noise Reduction” on page 24.
								4 Set the REVERSE MODE switch to		to record on only
								one side, or to	for continuous recording on both sides.
								5 Press the REC button.
								* The indicator next to the REC button will light up and
								the play indicator flash.
								6 Press the play button of the CD.
								* Before CD playback begins, recording automatically
								begins on side A of the tape.
								To stop recording temporarily
								1 Press the pause button of the CD.
								2 Press the play button of the CD to resume recording.
4	3		5			2		To stop recording
								Press the stop	button of the tape deck.
								(At this time, CD playback does not stop.)
	1	2	3	4	5
	6	7	8	9	0
	PROG	CLEAR	CALL	TIME	+10		1
	REPEAT				CD		1
5				BAND TUNER
	b
	a						6,2
	HALL	JAZZ CLUB ROCK CNCT		OFF	TAPE
	POWER	AUX	DAT	- VOLUME +

E-26