TUNER OPERATION
4 2 3
1
1 | 2 | 3 | 4 | 5 |
|
6 | 7 | 8 | 9 | 0 |
|
PROG | CLEAR | CALL | TIME | +10 |
|
3 |
|
|
|
|
|
REPEAT |
|
|
| CD | 1 |
b |
|
| BAND | TUNER | |
a |
|
|
|
| 2 |
HALL | JAZZ CLUB | ROCK CNCT | OFF | TAPE |
|
POWER | AUX | DAT | - VOLUME + |
| |
3
To recall a memorized station
1
2 Select the desired frequency band. [FM or AM (LW or MW)]
3 Press the TUNER PRESET ( 
or 
) button to recall the desired preset station number. The caption FM or AM (LW or MW) and a frequency will appear in the display.
4 To set to FM stereo mode, press the FM MODE button so that the “STEREO” indicator on the display lights up. If the reception is poor, press the FM MODE button so that the “STEREO” indicator goes out.
*The “AUTO ST” indicator lights up when an FM broadcast is in stereo.
*Please note that when the unit is being tuned in the FM stereo mode, interim station noise as well as weak stations are suppressed. Only in the FM monaural mode, weak and noisy stations can be received.
To switch the unit off after use
Set the unit to the STANDBY mode by pressing the POWER switch. (The indicators will go off except for the STANDBY indicator and the current time display.)
Notes
•Memory recalls the last station received even after changing the BAND selector button or setting the unit to the STANDBY mode.
•After a power failure that lasts for some time, the contents of the memory will be lost. When power is restored, store your selections in memory again.
(For power failures of just a few hours, the contents of the memory will not be lost.)
To clear all memorized stations
To clear all the memory contents or when the display is incorrect:
1 Set the unit to the STANDBY mode.
2 Disconnect the AC supply lead from the AC outlet.
3 Press the RESET button for at least 60 seconds.