Select the TAPE position.

CASSETTE TAPE OPERATION

Detection holeTab

1

3

3

(a)(b)

 

4

2(a) 5 6(a)6(b) 2(b)

General information

•Do not use C-120 tapes, tapes with internal reels or poor- quality tapes, since they can cause malfunctions.

•Before loading a tape into the cassette compartment, tighten the slack tape with a pen or pencil.

•Tapes have removable tabs which prevent accidental recording or erasing from taking place. Removing the tab on the top left protects the side facing you from erasure. Cover the tab holes with adhesive tape to erase or record again.

•This deck is a Double Cassette Deck with Automatic Reverse Function.Tape “a”: Playback only.Tape “b”: Playback or recording.

•This deck features an auto tape selector. Just load the tape, and the tape formula being used will be sensed automatically.

•This unit can playback metal tapes as well as normal or chrome tapes, however recording cannot be done on metal tapes only.

•When covering erasure prevention tab holes, do not cover the chrome and metal detection holes. Otherwise, the deck will treat tape as normal tape.

•Do not press the EJECT button during playback or recording.

Tape “a” or tape “b” playback

1

2 Open the tape “a” or tape “b” cassette compartment by pushing the EJECT button.

3 Load the cassette into the tape “a” or tape “b” cassette compartment.

4 Set the DOLBY NR switch to B or C if the tape has been recorded with Dolby noise reduction, and to OFF if Dolby NR was not used.

*For selection of the Dolby B or C position, refer to the “Dolby B and C Type Noise Reduction” on page 24.

5 Set the REVERSE MODE switch as desired.

The REVERSE MODE switch can be operated before or during playback, and changes tape playback as follows:

 

Side A → Side

Side A → Side B

Side A only

B

Continuous play

 

 

Side B only Side B only

Side B → Side A Continuous play

6 Press the play button to listen to side A, or the play button for side B.

E-22