CLP-295GP Owner’s Manual 111
Appendix
CLP-295GP: Keyboard Stand Assembly
CAUTION
•Be careful not to confuse parts, and be sure to install
all parts in the correct orientation. Please assemble
in accordance with the sequence given below.
•Assembly should be carried out by at least two per-
sons.
•Be sure to use the correct screw size, as indicated
below. Use of incorrect screws can damage the
stand.
•Be sure to tighten all screws upon completing the
assembly of each unit.
•To disassemble, reverse the assembly sequence given
below.
The CLP-295GP features an iAFC (Instrumental Active Field
Control) effect. This produces sound from the speaker
located on the bottom face of the Clavinova, enhancing the
reverberation and spaciousness of the sound when you open
the lid with the longer stay (page 15).
In order to optimize the iAFC effect, please observe the fol-
lowing:
•Perform the automatic adjustment after you turn on the
power of the Clavinova for the first time, and after each
time you re-locate the Clavinova. (page 84)
•Do not block the speaker located on the bottom face of the
Clavinova.
1. Remove all parts from the box. Con-

firm that all parts shown in the illus-

tration are included.

Main unit
How to position the main unit
Spread a large soft cloth, such as a blanket, on the floor.
Place the unit on the cloth with the key cover closed
and the keyboard side on the bottom and lean the unit
against the wall so that the unit will not fall or slip.
Place a soft cloth against the wall to protect the instru-
ment and the wall from scratches.
Have a Phillips-head (+) screwdriver ready.
TIP
Lean the unit against the
wall as shown at right.
Lean the unit against the
wall as shown at right.
Legs Pedal box
6 × 40 mm fixing screws
× 12
AC power cord Cord holder
6 × 20 mm fixing screws
× 4
CAUTION
Be careful not to pinch your fingers.
Be sure to position the keyboard side on the bottom.
CAUTION
Do not place the main unit with
the rear side facing down.
CAUTION
Do not lay the main unit upside
down on the floor.
CAUTION
Do not position the main unit so
that its bottom is in contact with
floor.