BASIC OPERATION

When you finish using this unit

Press the STANDBY/ON switch on the front panel or the STANDBY key on the remote controller to enter the standby mode.

Front panel

Remote control

STANDBY/ON

or

STANDBY

To select the source connected to this unit’s EXTERNAL DECODER INPUT terminals as the input source.

Press the EXT. DECODER button. “EXT. DECODER IN” will appear on the display.

Front panel

Remote control

EXT. DECODER

EXT. DEC.

 

 

or

Note

The input source selected in this way has priority over any other input source already selected.

To select another input source, press the EXT. DECODER button again so that “EXT. DECODER IN” goes off from the display, and then use the INPUT SELECTOR.

Notes on input source selection

●Note that selecting an input source means that the source which is connected to the corresponding input terminals on the rear panel is selected.

*To select the source connected to the VIDEO AUX terminals on the front panel, select “V-AUX”.

●The setting of the EXT. DECODER button cannot be canceled by selecting another input source. To cancel it, press the EXT. DECODER button again so that “EXT. DECODER IN” goes off from the display.

●If you select a video input source without canceling the setting of the EXT. DECODER button, you will see the picture of the video input source and hear the sound of the source selected by the EXT. DECODER button.

●If a different audio source is selected with the input selector keys on the remote controller while enjoying a video source, the sound from the newly selected audio source is heard, but the picture from the video source can still be seen.

●When you select an input source, the DSP program (or the state of no DSP program is used) which was used when the same input source was last selected will be automatically recalled.

●If a nonstandardized source is played back, or the unit playing back a source is not operating correctly, “INPUT DATA ERR” appears on the display.

34