REMOTE CONTROLLER

Methods of learning and clearing functions

mLearning a new function

1Place this remote controller and the other remote controller so that they face each other.

This remote controller

Other remote controller

-

About 5 (2–4 in.)

2

 

 

TRANSMIT

 

 

/LEARN

CLEAR

LEARN

MACRO

(Press by using a ball-point

Flashes slowly.

pen or similar object.)

 

*If there is no operation for about 30 seconds after the LEARN button is pressed, the TRANSMIT/LEARN indicator flashes rapidly and the current mode is canceled. Repeat this step.

3 If necessary, select the memory area by using the A/B/C switch on the side panel of the remote controller.

4 Press the key on this remote controller in which you will store a new function.

Lights up.

*which cannot learn another function is pressed, the TRANSMIT/LEARN indicator flashes rapidly and the current mode is canceled. Repeat this step.

*If there is no operation for about 30 seconds after a key is pressed, the TRANSMIT/LEARN indicator flashes rapidly and the mode before you began learning operations is

restored. Restart from step 2.

5 Press and hold the key (on the other remote controller) which has the function you want to store.

-

is finished, the TRANSMIT/LEARN indicator

. You can release the key. Then the indicator begins flashing slowly.

*If a signal is not successfully received, the TRANSMIT/LEARN indicator flashes rapidly and the mode prior to step 4 is restored. Restart from step 4.

*If memory capacity is full, the TRANSMIT/LEARN indicator flashes rapidly to show you that learning is impossible, and then the mode before you began learning operations is restored.

6 Repeat steps 3–5 to store more functions.

7 When you finish the learning operation, press the LEARN button.

CLEAR LEARN MACRO

Notes

●Newly learned functions will replace previously learned functions.

●If there is no more room in the memory area for a function to be learned, the TRANSMIT/LEARN indicator will flash rapidly. In this case, even if some keys are not occupied with functions from other remote controllers, no further learning is possible.

●If you close the cover while learning, and then about 5 seconds pass, the TRANSMIT/LEARN indicator flashes rapidly and the mode before beginning learning operations is restored. Restart from step 2. However, if you open the cover within 5 seconds, the mode before closing the cover is restored.

●There may occasionally be instances in which, due to the signal-coding and modulation employed by the other remote controller, this remote controller will not be able to “learn” its signals.

●When you press the LEARN, MACRO or CLEAR button, or the RESET button inside of the battery compartment by using a sharp-pointed thing, be careful not to damage the button. If you will use a mechanical pencil, make sure that

the lead is retracted.

68