ON-SCREEN DISPLAY (OSD)
You can display the operation information for this unit on a video monitor. If you display the SET MENU and DSP program parameter settings on a monitor, it is much easier to see the available options and parameters than it is by reading this information on the front panel display.
y
•If a video source is being reproduced, the OSD is superimposed over the image.
•The OSD signal is not output to the REC OUT jack, and will not be recorded with any video signal.
•You can set the OSD to turn on (blue background) or off when a video source is not being reproduced (or the source component is turned off) by using “9 DISPLAY SET” on the
SET MENU.
OSD Modes
You can change the amount of information the OSD shows.
Full display
This mode always shows the DSP program parameter settings on the video monitor.
Short display
This mode briefly shows the same contents as the front panel display at the bottom of the screen and then disappears.
Display off
This mode briefly shows the “DISPLAY OFF” message at the bottom of the screen and then disappears. Afterwards, no changes to operations appear on the monitor except those of the ON SCREEN button.
P01 CONCERT HALL
INIT. DLY 
45ms
ROOM SIZE 
1.0
LIVENESS 
5
P01 CONCERT HALL
Full display | Short display |
y
•When you choose the full display mode, INPUT l/ h, VOLUME and some other types of operation information are displayed at the bottom of the screen in the same format as that for the front panel display.
•The SET MENU and test tone display appear regardless of the OSD mode.
Selecting the OSD Mode
1 When you turn on the power, the video monitor and front panel display show the level of the main volume for a few seconds and then switch to show the current DSP program.
2 Press ON SCREEN on the remote control repeatedly to change the display mode.
The OSD mode changes in the following order: full display, short display, and display off.
Notes
•If you choose a video input source that has a component connected to both the S VIDEO IN and composite VIDEO IN jacks, and both the S VIDEO OUT and composite VIDEO OUT jacks are connected to a video monitor, the video signal is output to both the S VIDEO OUT and VIDEO OUT jacks. However, the OSD is carried only on the
•If your video monitor is connected only to the COMPONENT VIDEO jacks of this unit, the OSD is not shown. Make sure to connect your video monitor to the COMPONENT VIDEO jacks and either VIDEO or S VIDEO jacks if you want to see the OSD.
•Playing back video software that has an
20