The state of the test tone output is also shown on the monitor by an image of the audio listening room. This is convenient for adjusting each speaker level.
TEST DOLBY SUR.LEFT
y
•If “1A CENTER SP” on the SET MENU is set to NONE, the center channel sound is automatically output from the left and right main speakers.
Note
•If the test tone cannot be heard, turn down the volume, set the unit in the standby mode and check the speaker connections.
4 Press LEVEL repeatedly to select the speaker to be adjusted.y
•Once you press LEVEL, you can also select the speaker to be adjusted by pressing d. (Pressing uchanges the selection in the reverse order.)
5 Press j / i repeatedly to adjust the output level of the currently selected speaker so that it becomes almost the same as that of the main speaker.
•While adjusting, the test tone is heard from the selected speaker.•Repeat steps 4 and 5 to adjust the output levels of the center, left rear and right rear speakers.
6 When the adjustment is complete, press TEST.The test tone stops and the current DSP program appears on the front panel display and on the video monitor.
ADJUSTING THE SPEAKER OUTPUTCONNECTIONSLEVEL
Notes
•For details on adjusting the subwoofer speaker, refer to the effect speaker level adjustment described on page 38.
•After adjusting with the test tone, it is possible to adjust the speaker level to taste while listening to the playback of an actual source when using the effect speaker level adjustment described on page 38.
y
•You can increase the output levels of the effect speakers (center, left rear and right rear) to +10 dB. If the output level of these speakers is lower than that of the main speakers even after you have increased the output level of these speakers up to +10 dB, set “1E MAIN LEVEL” on the SET MENU to
PREPARATION
English
23