E

ADJUSTING TRIM ANGLE

EMU00951

Manual tilt model

There are 4 or 5 holes provided in the clamp bracket to adjust the outboard motor trim angle.

1)Stop the engine.

2)Remove the trim angle adjusting rod 1 from the clamp bracket while tilting the motor up slightly.

3)Reposition the rod in the desired hole. To raise the bow (“trim-out”), move the

 

 

rod away from the transom.

 

 

To lower the bow (“trim-in”), move the

 

 

rod toward the transom.

 

 

Make test runs with the trim set to differ-

 

 

ent angles to find the position that works

q

best for your boat and operating condi-

tions.

 

w

 

 

001805

 

 

8Stop the engine before adjusting the trim angle.

8Use care to avoid being pinched when removing or installing the rod.

8Use caution when trying a trim position for the first time. Increase speed gradu- ally and watch for any signs of instabili- ty or control problems. Improper trim angle can cause loss of control.

NOTE:

The outboard motor trim angle can be changed approximately 4 degrees by shifting the trim adjusting-rod one hole.

3-21