E
EML19010
Installing the Propeller
cC
8Be sure to install the thrust washer before installing propeller, otherwise, lower case and propeller boss may be damaged.
8Be sure to use a new cotter pin and
602053 |
| bend the ends over securely. |
|
| |
|
| Otherwise, the propeller could come off |
|
| |
|
| during operation and be lost. |
|
|
|
1)Apply Yamaha Marine grease or a corrosion resistant grease to the pro-
2)Install the thrust washer and propeller on the
3)Install the washer and tighten the pro- peller nut to the specified torque.
Tightening torque:
Refer to “SPECIFICATIONS” page
4)Align the propeller nut with the pro- peller shaft hole. Insert a new cotter pin in the hole and bend the cotter pin ends.
NOTE:
When the propeller nut does not align with the propeller shaft hole after tightening to the specified torque, then tighten the nut further to align it with the hole.