E

UP UPDN DN

701034

EMU01414

Power Tilt Model

w

8Be sure all people are clear of the out- board motor when adjusting the tilt angle, also be careful not to pinch any body parts between the drive unit and clamp bracket.

8Use caution when trying a trim position for the first time. Increase speed gradu- ally and watch for any signs of instabili- ty or control problems. Improper trim angle can cause loss of control.

8Use the power tilt switch located on the bottom engine cowling (if equipped) only when the boat is at a complete stop with the engine off.

DN UP

000610

1)Place the gear-shift lever in the neu- tral position.

2)Tilt the engine to the desired angle using the power tilt switch.

NOTE:

Stay within the trim operating angle when trimming the outboard motor using the power tilt system.

To raise the bow (“trim-out”), tilt the engine up.

To lower the bow (“trim-in”), tilt the engine down.

Make test runs with the trim set to different angles to find the position that works best for your boat and operating condi- tions.

3-22