E
NOTE:
If a torque wrench is not available when you are installing the drain plug, finger tighten the bolt just until the gasket comes into contact with the surface of the drain hole. Then tighten 1/4 - 1/2 turn. Have the drain plug torqued to the correct value with a torque wrench as soon as possible.
4)Remove the oil filler cap 2. Add the
|
|
| correct amount of oil through the |
|
|
| filler hole. |
|
|
| Reinstall the filler cap. |
|
|
|
|
|
|
| Engine oil grade/capacity: |
|
|
| Refer to “SPECIFICATIONS”, page |
w |
|
|
|
|
| 5) Start the engine and watch to make | |
|
|
| |
| 203026* |
| sure the low oil pressure warning |
|
| lamp turns off. Make sure that there | |
|
|
| |
|
|
| are no oil leaks. |
cC
If the oil lamp does not turn off, or if there are oil leaks, stop the engine and find the cause. Continued operation with a problem could cause severe engine damage. If the problem cannot be found and corrected, consult your Yamaha deal- er.
6)Turn off the engine and wait 3 min- utes. Recheck the oil level using the dipstick to be sure the level falls between the upper and lower marks. Fill with oil if it is below the lower mark, or drain to the specified level if it is above the upper mark.
7)Dispose of used oil according to local regulations.