E

EJU01861

Start switch

Push the start switch 1 (green button) to start the engine.

NOTE:

The engine will not start when the clip is removed from the engine shut-off switch or if the throttle lever is squeezed.

EJU01784

Cooling water pilot outlet

This watercraft is equipped with cooling water pilot outlets.

When the engine is running, cooling water is circulated in the engine, and then it is discharged from the pilot outlets.

To check for proper operation of the cooling system, check that water is being discharged from the port (left) pilot outlet. If water is not being discharged from this out- let, cooling water may not be circulating in the engine. When this occurs, stop the engine and check for the cause. (See pages 2-19 and 5-3 for further instructions.)

NOTE:

●If the cooling water passages are dry, it will take about 60 seconds for the water to reach the outlet after the engine is started.

●Water discharge may not be constant at idle, therefore, open the throttle a little to check that water discharges properly.

●Water discharge may not be constant at the starboard (right) pilot outlet, however, if it is constant at the port (left) pilot outlet, the cooling system is operating normally.

2-9