E

EJU19011

Lubrication

WARNING

Do not spray flammable rust inhibitor products on engine surfaces while the engine is hot. The sprayed substance or propellants could catch fire.

1.Remove the rear and front seats. (See pages 2-5 to 2-6 for seat removal and installation procedures.)

2.Remove the air filter case cover screws 1, slide the locks 2 open, and then remove the case cover.

3.Remove the air filter case cover and air filter element.

4.Spray a rust inhibitor such as Yamaha Stor-Rite Engine Fogging Oil into each intake opening 3 for 3 seconds.

5.Install the air filter element and air filter case cover.

6.Start the engine in a well-ventilated area and let it run at idle for 15 seconds.

CAUTION:

Do not run the engine for more than 15 seconds. The engine could overheat.

7.Lubricate all cables such as the throttle and steering cables.

NOTE:

Use a Yamaha Power Cable Luber and Yamaha Lube-Zall to pressure lubricate the cables and purge out any moisture between the inner and outer cables.

8.Lubricate the areas of the watercraft specified under Lubrication points on page 4-17.

4-3