E

Checking the engine oil level again:

1.Launch the watercraft, and then start the engine.

2. Run the engine at 7,000 r/min for

5 minutes or more and at trolling speed for 2–3 minutes, and then turn the engine off.

3.Remove the oil tank filler cap, wipe the dipstick clean, and then screw the filler cap into the filler hole completely. Remove the filler cap again to check the oil level.

4.If the engine oil is below the minimum level mark, add sufficient oil of the rec- ommended type to raise it to the correct level. If the engine oil is above the maxi- mum level mark 3, extract sufficient oil to lower it to the correct level.

NOTE:

●The engine oil should be between the minimum and maximum level marks.

●To check the engine oil level accurately, be sure to adequately warm the engine up.

3-9