TUNING OPERATIONS

Set INPUT on the front panel to the TUNER position. When using the remote control transmitter, press AMP<TUNER> on the component selector and then press TUNER on the input selector.

Normally, if station signals are strong and there is no interference, quick automatic-search tuning (AUTOMATIC TUNING) is possible. However, if the signal from the station you want to select is weak, you must tune in to it manually (MANUAL TUNING).

2 3

1

AUTOMATIC TUNING

1 Select the reception band (FM or AM) and confirm it on the display.

Front panel

or

2 Press TUNING MODE so that the “AUTO TUNING” indicator lights up on the display.

Front panel

Lights up

3 To tune in to a higher frequency, press the UP side of TUNING once.

To tune in to a lower frequency, press the DOWN side of TUNING once.

Front panel

*If the station where the tuning search stops is not the desired one, press once more.

*If the tuning search does not stop at the desired station (because the signal from the station is weak), take the manual tuning procedure.

MANUAL TUNING

1 Select the reception band (FM or AM) and confirm it on the display.

Front panel

or

2 Press TUNING MODE.

Front panel

Confirm that the “AUTO

TUNING” indicator goes off.

3 Tune in manually to the desired station.

Front panel

* To continue the tuning search, press and hold the button.

Note

If you tune in manually to an FM station, it will be automatically received in monaural mode to increase the signal quality.

32