Yamaha HTR-5630RDS owner manual Troubleshooting, Problem, Solution

Troubleshooting

Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below or if the instruction below does not help, set this unit to the standby mode, disconnect the power cord, and contact the nearest authorized YAMAHA dealer or service center.

Problem	Solution
No power	– Check if the AC power cord is properly connected.
No picture	– Check if the TV is switched on.
	– Check the video connection.
	– If you did not use Progressive Scan connections (using the Y PB
	PR jacks on the DVD Player) and you do not have a picture at the
	TV, please follow the steps below to turn off Progressive Scan;
	1. Press / (OPEN/CLOSE) to open the disc tray.
	2. Press 2.
	3. Then press MUTE to deactivate the Progressive. The DVD
	Player will reset itself to Component/Interlaced video. The disc
	tray will closed automatically to let you know it has reset itself.
Distorted picture	– The disc is badly scratched or dirty.
	– Sometimes a small amount of picture distortion may appear.
	This is not a malfunction.
Completely distorted picture or black/	– Make sure the NTSC/PAL setting at the DVD player matches the
white picture with DVD or Video CD	video signal of your television. (See NTSC/PAL CONVERSION)
No sound or distorted sound	– Adjust the volume.
	– Check that the speakers are connected correctly.
No audio at digital output	– Check the digital connections.
	– Check if your receiver can decode MPEG-2 or DTS and if not,
	please make sure the digital output is set to PCM.
	– Check if the audio format of the selected audio language matches
	your receiver capabilities.
Disc can’t be played	– The DVD+R/DVD+RW/DVD-R/DVD-RW/CD-R/CD-RW
	must be finalized.
	– Ensure the disc label is facing up.
	– Check if the disc is defective by trying another disc.
	– If you have recorded this particular Picture CD or MP3 CD
	yourself, please ensure that your disc contains at least about 6~10
	pictures or 3~5MP3 music tracks before using it with the player.

No return to start-up screen when disc is removed

– Reset the unit by switching the player off, then on again.

The player does not respond to the remote control

–Aim the remote control directly at the sensor on the front of the player.

–Reduce the distance to the player.

–Replace the batteries in the remote control.

–Insert the batteries with their polarities (+/– signs) as indicated.

Buttons do not work	–	In order to completely reset the player, unplug the AC cord from
		the AC outlet.
Player does not respond to some	–	Operations may not be permitted by the disc. Refer to the
operating commands during playback		instructions of the disc.

DVD Video player cannot read CDs/ DVDs

–Use a commonly available cleaning CD/DVD to clean the lens before sending the DVD Video player for repair.

22