Yamaha HTR-5950 ■Speaker impedance SP IMP, ■Factory presets PRESET, ■Remote control AMP ID REMOTE AMP, ■Remote control TUNER ID REMOTE TUN, ■Remote control XM ID REMOTE XM

■Speaker impedance SP IMP.

Use this feature to set the speaker impedance of this unit so that it matches that of your speakers.

Choices: 8ΩMIN, 6ΩMIN

•Select “8ΩMIN” to set the speaker impedance to 8 Ω .

•Select “6ΩMIN” to set the speaker impedance to 6 Ω .

SP IMP.	Speaker	Impedance level
		If you use one set (A or B),
		the impedance of each
		speaker must be 8 Ω or
		higher.
	Front
		If you use two sets (A and
		B), the impedance of each
8ΩMIN		speaker must be 16 Ω or
		higher.*
	Center
		The impedance of each
	Surround	speaker must be 8 Ω or
		higher.
	Surround back
		If you use one set (A or B),
		the impedance of each
		speaker must be 4 Ω or
		higher.
	Front
		If you use two sets (A and
		B), the impedance of each
Ω		speaker must be 8 Ω or
6 MIN		higher.
	Center
		The impedance of each
	Surround	speaker must be 6 Ω or
		higher.
	Surround back

*The Canada model cannot use two separate speaker systems (A and B) simultaneously when “SP IMP.” is set to “8ΩMIN”.

■Factory presets PRESET

Use this feature to reset all the parameters of this unit to the initial factory settings (see page 97).

Choices: CANCEL, RESET

•Select “CANCEL” not to reset any parameters of this unit.

•Select “RESET” to reset the parameters of this unit.

Notes

•This setting completely resets all the parameters of this unit including the “SET MENU” parameters. However, the advanced setup menu parameters will not be initialized.

•The initial factory settings are activated next time you turn on this unit.

ADVANCED SETUP

■Remote control AMP ID REMOTE AMP

Use this feature to set the AMP ID of this unit for remote control recognition (see page 93).

Choices: ID1, ID2

• Select “ID1” when the remote control AMP ID library code is set to “00001”.

• Select “ID2” when the remote control AMP ID library code is set to “00002”.

Note

You need to set the corresponding remote control AMP library code for the remote control (see page 93).

■Remote control TUNER ID REMOTE TUN

Use this feature to set the TUNER ID of this unit for remote control recognition (see page 93).

Choices: ID1, ID2

• Select “ID1” when the remote control TUNER ID library code is set to “81916”.

• Select “ID2” when the remote control TUNER ID library code is set to “81917”.

Note

You need to set the corresponding remote control TUNER library code for the remote control (see page 93).

■Remote control XM ID REMOTE XM

(U.S.A. model only)

Use this feature to set the XM ID of this unit for remote control recognition (see page 94).

Choices: ID1, ID2

•Select “ID1” when the remote control XM ID library code is set to “81918”.

•Select “ID2” when the remote control XM ID library code is set to “81919”.

Note

You need to set the corresponding remote control XM library code for the remote control (see page 93).

OPERATION ADVANCED

89