Yamaha HTR-6060 <XM>123, Xm Xm, 55 En, All Channel Search mode, Category Search mode, Search”

Before performing operations, set the operation mode selector on the remote control to KSOURCE.

■All Channel Search mode

1Press 2SEARCH MODE (or NSRCH MODE) repeatedly to select “ALL CH

SEARCH”.

2Press 5PRESET/TUNING/CH l / h (or

DPRESET/CH k / n) repeatedly to search for a channel within all channels.

y

•You can search for a channel quickly by pressing and

holding 5PRESET/TUNING/CH l/ h(or DPRESET/CH k/ n).

•To display the XM Radio ID number displayed in the front panel display, select channel “0”.

■Category Search mode

1Press 2SEARCH MODE (or NSRCH MODE) repeatedly to select “CAT SEARCH”.

2Press 4CATEGORY (or DA-E/CAT.l / h) repeatedly to change the channel category.

3Press 5PRESET/TUNING/CH l / h (or

DPRESET/CH k / n) repeatedly to search for a channel within the selected channel category.

y

You can search for a channel quickly by pressing and

holding 5PRESET/TUNING/CH l/ hon the front panel (or DPRESET/CH k/ non the remote control).

■Preset Search mode

Prior to selecting a preset channel in the Preset Search mode, you must preset XM Satellite Radio channels. For details, see “Setting the XM Satellite Radio preset channels” on page 56.

y

The initial factory setting of all preset channels (A1 to E8) is “[001] Preview”.

1Press 2SEARCH MODE (or NSRCH MODE) repeatedly to select “PRESET

SEARCH”.

2Press 4CATEGORY (or DA-E/CAT.l / h) repeatedly to change the preset channel group (A to E).

XM Satellite Radio tuning

3Press 5PRESET/TUNING/CH l/ h (or

DPRESET/CH k/ n) repeatedly to change the preset channel number (1 to 8).

y

You can also select the preset channel number directly by pressing the numeric buttons (1 to 8) (B).

■Direct number access mode

1Press NSRCH MODE on the remote control repeatedly to select “ALL CH SEARCH” or “CAT SEARCH”.

2Press the numeric buttons (B) to enter the desired three-digit channel number.

For example, to enter the number 123, press the numeric buttons (B) as shown below.

CLASSICAL	LIVE/CLUB	ENTERTAIN
		3
1	2

The display changes as follows.

<XM> --1

<XM> -12

<XM>123

y

•To enter a one-digit or two-digit channel number, press the numeric buttons (B) on the remote control and then press MENT to confirm the input number.

•Instead of pressing MENT to tune into the channel immediately, you can wait a few seconds until this unit confirms the entered channel number.

•If no button is pressed within a few seconds after you enter a one-digit or two-digit number, this unit automatically confirms the entered channel number.

•Pressing a button other than the numeric buttons (B) or MENT cancels the Direct Number Access mode

procedure.

OPERATION BASIC

English

55 En