Setting the speaker impedance
Caution
If you are to use 6 ohm speakers, set “SP IMP.” to
“6Ω MIN” as follows BEFORE using this unit. 4 ohm speakers can be also used as the front speakers.
1Make sure this unit is turned off.
Refer to the right column for details.
2Press and hold BTONE CONTROL on the front panel and then press ASTANDBY/ON
to turn on this unit.
This unit turns on, and the advanced setup menu appears in the front panel display.
TONE CONTROL While holding down
STANDBY
/ON
3Rotate the CPROGRAM selector on the front panel to select “SP IMP.”.
“SP IMP.” and the current speaker impedance setting (“8Ω MIN”) appear in the front panel display.
4Press BTONE CONTROL on the front panel repeatedly to select “6Ω MIN”.
5Press ASTANDBY/ON on the front panel to save the new setting and turn off this unit.
Connections
Turning this unit on and off
■Turning on this unit
Press ASTANDBY/ON on the front panel to turn on this unit.
When you turns on this unit by pressing ASTANDBY/ ON, this unit is turned on.
y
When you turn on this unit, there will be a 4 to
■Set this unit to the standby mode
Press ASTANDBY/ON (or GSTANDBY) to set this unit to the standby mode.
In the standby mode, this unit consumes a small amount of power in order to receive infrared signals from the remote control.
y
•You can also turn on this unit by pressing ESCENE (or FSCENE) buttons.
•When you turn on this unit, there will be a 4 to
PREPARATION
Note
The setting you made is reflected next time you turn on this unit.
English
