Automatic preset tuning
You can use the automatic preset tuning feature to store up to 40 FM stations with strong signals (A1 to E8: 8 preset station numbers in each of the 5 preset station groups) in order. You can then recall any preset station easily by selecting the preset station number.
1Rotate the HINPUT selector on the front panel to select “TUNER” as the input source.
2Press 3FM/AM to select “FM” as the reception band.
“FM” appears in the front panel display.
3Press and hold 6MEMORY for more than 3 seconds.
The preset station number as well as the MEMORY and AUTO indicators flashes. After approximately 5 seconds, automatic presetting starts from the current frequency and proceeds toward higher frequencies.
Flashes
AUTOMEMORY
A1:FM
Flashes
When automatic preset tuning is completed, the front panel display shows the frequency of the last preset station.
y
•You can specify the preset number from which this unit stores FM stations. Press 4A/B/C/D/E and then
5PRESET/TUNING/CH l/ hrepeatedly after you perform step 3 to select the preset station number under which the first station will be stored.
•You can begin tuning toward lower frequencies to store FM stations automatically. Press 2PRESET/TUNING so that the colon (:) disappears from the front panel display and then press 5PRESET/TUNING/CH lafter pressing and holding 6MEMORY for more than 3 seconds.
FM/AM tuning
Notes
•Any stored station data existing under a preset station number is cleared when you store a new station under the same preset station number.
•If the number of received stations does not reach 40 (E8), automatic preset tuning automatically stops after searching for all the available stations.
•Only FM stations with sufficient signal strength are stored automatically by automatic preset tuning. If the station you want to store is weak in signal strength, tune into it manually and store it as described in “Manual preset tuning” below.
Manual preset tuning
You can also store up to 40 stations (A1 to E8: 8 preset station numbers in each of the 5 preset station groups) manually.
1Tune into a station.
See page 50 for tuning instructions.
2Press 6MEMORY on the front panel.
The MEMORY indicator flashes in the front panel display for approximately 10 seconds.
MEMORY
Flashes
3Press 4A/B/C/D/E repeatedly to select a preset station group (A to E) while the MEMORY indicator is flashing.
The selected preset station group letter appears. Check that the colon (:) appears in the front panel display.
Flashes
MEMORY
A
Preset station | Colon (:) |
group |
|
OPERATION | BASIC |
|
|
English
