Yamaha IMX644 OUTPUT screen

IMX644 Manager Owner’s Manual 18

Here you can edit parameters other than EQ for output channels 1–4.

1Output level meter/indicator

Output level meters

Shows level meters for the output signals of OUTPUT channels 1 and 2.

Output indicators

Shows [-2 dBFS]/[-44 dBFS] indicators for the output signals of OUTPUT channels 3 and 4.

The [-44 dBFS] indicator will light green when an output signal is detected at the corresponding channel.

If the [-2 dBFS] (PEAK) indicator lights red, the output signal has reached the maximum allowable level. Lower the input vol-

ume or the output volume.

2[DELAY] button

Opens the “DELAY” dialog box, allowing you to specify the delay time for each OUTPUT channel. These parameters are the

same as in the BLOCK screen’s “DELAY” dialog box; refer to page 14 for details.

3[EQ] button

This button opens the OUTPUT EQ screen (page 19), allowing you to edit the parameters of the 6-band equalizers provided

for OUTPUT channels 1 through 4.

4[BALANCE] knob

This knob adjusts the volume balance between outputs

A/B (L/R) for OUTPUT channels 1 and 2.

Right-click the [BALANCE] knob and continue holding

down the mouse button to decrease the A (L) volume;

left-click and hold down the mouse button to decrease the

B (R) volume. Double-click to reset the value to center.

5[STEREO/MONO] button

This button specifies the mode of the output channel. Click it to switch between STEREO and MONO.

6[LINK] button, fader, marker, [LOCK] button

Here you can adjust the volume of the output channel. These parameters are the same as in the BLOCK screen’s “LEVEL”

dialog box; refer to page 14 for details.

OUTPUT screen

Press (hold)

the left button

Press (hold)

the right button

Parameter Range Default

Balance 0dB – -20.1dB 0dB