Components

A

1

2

1.Trim tab

2.Bolt

B

ZMU03097

ZMU03194

ECM00660

NOTICE

Bolt tightening torque:

36.0 Nm (3.6 kgf-m, 26 ft-lb)

EMU26261

Trim rod (tilt pin)

The position of the trim rod determines the minimum trim angle of the outboard motor in relation to the transom.

Do not use the tilt support lever or knob when trailering the boat. The outboard motor could shake loose from the tilt support and fall. If the motor cannot be trailered in the normal running position, use an additional support device to secure it in the tilt position.

EMU26372

Top cowling lock lever(s) (turn type)

To remove the engine top cowling, turn the lock lever(s) and lift off the cowling. When installing the cowling, check to be sure it fits properly in the rubber seal. Then lock the cowling again by returning the lever(s) to the lock position.

ZMU02526

EMU26341

Tilt support lever for power trim and tilt model

To keep the outboard motor in the tilted up

1

position, lock the tilt support lever to the

 

clamp bracket.

ZMU03827

1. Top cowling lock lever(s)

26