Operation

1. Trim operating angle

EMU27884

Adjusting trim angle (Power trim and tilt)

EWM00753

WARNING

●Be sure all people are clear of the out- board motor when adjusting the trim angle. Body parts can be crushed be- tween the motor and the clamp bracket when the motor is trimmed or tilted.

●Use caution when trying a trim position for the first time. Increase speed gradu- ally and watch for any signs of instabil- ity or control problems. Improper trim angle can cause loss of control.

●If equipped with a power trim and tilt switch located on the bottom cowling, use the switch only when the boat is at a complete stop with the engine off. Do not adjust the trim angle with this switch while the boat is moving.

Adjust the outboard motor trim angle using the power trim and tilt switch.

UP

DN

1

ZMU03110

1. Power trim and tilt switch

1. Power trim and tilt switch

UP

DN

1

ZMU04515

1. Power trim and tilt switch

To raise the bow (trim-out), press the switch “” (up).

To lower the bow (trim-in), press the switch “” (down).

Make test runs with the trim set to different

50