Yamaha LIT-18626-07-93 Procedure for tilting down (power trim and tilt models)

	Operation
	and tilt switch “ ” (down) to retract the
	trim rods. NOTICE: Be sure to retract
	the trim rods completely during
	mooring. This protects the rods from
UP	marine growth and corrosion which
	could damage the power trim and tilt
	mechanism. [ECM00251]

ZMU03837

3.Pull the tilt support lever toward you to support the engine. WARNING! After tilting the outboard motor, be sure to support it with the tilt support knob or tilt support lever. Otherwise the out- board motor could fall back down suddenly if oil in the power trim and tilt unit or in the power tilt unit loses pressure. [EWM00262] NOTICE: Do not use the tilt support lever or knob when trailering the boat. The outboard mo- tor could shake loose from the tilt support and fall. If the motor cannot be trailered in the normal running po- sition, use an additional support de- vice to secure it in the tilt position. For more detailed information, see

page 56. [ECM01641]

ZMU03116

EMU33120

Procedure for tilting down (power trim and tilt models)

1.Push the power trim and tilt switch “” (up) until the outboard motor is support- ed by the tilt rod and the tilt support lever becomes free.

2.Release the tilt support lever.

ZMU03115

4.Models equipped with trim rods: Once the outboard motor is supported with the tilt support lever, press the power trim

ZMU02569

3.Push the power trim and tilt switch “ ” (down) to lower the outboard motor to the desired position.

53