Trouble Recovery

ZMU02614

TIP:

When the engine does not start with this pro- cedure, see page 77.

EMU29671

Engine fails to operate

EMU29691

Ignition system malfunction

If the battery voltage is low or in the unlikely event of an ignition system malfunction, the engine speed may become erratic or the engine may stop. In such a situation, follow the procedure below.

1.Remove the CDI unit cover or electrical cover, if equipped.

2.Disconnect the yellow cord (emergency

circuit) of the CDI unit to return to port.

EWM00350

WARNING

When the yellow cord is disconnected, the idle and low speeds are slightly higher than normal. Use care when starting off or stopping.

ECM00380

NOTICE

Follow this procedure only in an emergency and just long enough to return to port for repairs.

1

 

1

 

 

2

 

2

 

 

 

 

 

 

ZMU03843

 

 

 

 

 

 

 

1.CDI unit

2.Emergency connector

EMU29706

Cold engine fails to start

If the engine fails to start when it is cold, use the following procedure.

EWM00410

WARNING

When starting or operating the engine, do not touch the ignition coil, spark plug wire, spark plug cap, or other electrical parts carrying high voltage. Keep loose clothing and other objects away from the engine when starting it. Do not touch the flywheel or other moving parts when the engine is running.

1.Adjust the trim angle so that the drive shaft is at right angles to the water sur- face or is trimmed in.

2.On models equipped with an emergency starter valve, open it. The valve is locat- ed behind the silencer cover on the front of the engine.

77