MIDI UTILITY MODE SETTINGS

MIDI Utility mode

In addition to its Single, Dual, Split, and Demo Play modes, the P-100 has a MIDI Utility mode which allows you to
make a number of settings related to MIDI control functions. Below is a listing of the settings available in this mode:
SETTING DESCRIPTION BUTTONS
Transmit and receive channels MIDI + CHANNEL
Local control on/off MIDI + LOCAL
MIDI merge function on/off
Bulk protect on/off
Pitch bend range
Modulation wheel on/off
CS slider assignment
MIDI + MERGE
MIDI + PROTECT
MIDI + PB
MIDI + MW
MIDI + CS
Foot controller assignment MIDI + FC
Program change transmit table MIDI + PC TRNS
Program change receive table MIDI + PC RECV
You can enter MIDI Utility mode by pressing the appropriate [VOICE/UTILITY] buttons while holding down the
[MIDI] button.
When you do so, the LEDs above both the [MIDI] button and the [VOICE/UTILITY] button you pressed will begin
blinking, and the current setting for the parameter you selected will appear in the display. You can use either the
[DATA ENTRY] slider or the [-1] and [+l] buttons to change this setting.
When you’ve finished making your settings, press the [MIDI] button once again to exit MIDI Utility mode. Most of
the functions described previously (i.e., the voice selection, tuning and transpose functions, etc.) will not work while
the P-100 is in MIDI Utility mode; therefore. you will have to leave this mode in order to use these functions.
31