Yamaha P-100 <TABLE 1-1 >, 3.2 BULK DUMPS,

<TABLE 1-1 >

MIDI PARAMETER CHANGE TABLE (SYSTEM SETUP)

$F0, $43, $1n, $2A, $00, $00, $00, N2, $00, V2, $F7

Notes) n= device number (i.e., transmit/receive table)

N2 = parameter number

V2 = parameter value

When a parameter change message indicating the voice mode parameter

(VMODE, ppppppp=03) is received, the P-100 will enter the specified

voice mode, Any other system setup parameter change message will

simply change the indicated parameter to the specified value.

3.1.2 PROGRAM CHANGE TRANSMIT TABLE

Received program change transmit table parameter change messages will

change the indicated parameter to the specified value. regardless of the P-

100’s current mode.

3.1.3

PROGRAM CHANGE RECEIVE TABLE

Received program change receive table parameter change messages will

change the indicated parameter to the specified value, regardless of the

P-100’s current mode.

3.1.4 SWITCH REMOTE

Remote switch parameter change messages arc recognized but not

transmitted. These messages allow remote control of the functions

controlled by the P-100’s panel switches, and product the same results as

if the actual switches had been pressed. All switch remote parameter

change messages are recognized. regardless of the device number

specification.

Note) o/b = offset binary

Note)

Parameters with a data range of “off/on” are off when V2 equals

0, on otherwise.

Note)

The Effect Select and Depth parameters each consist of two 4-bit

nibbles. The lower 3 bits of the MS nibble indicate tch reverb

setting, while the lower 3 bits of the LS nibble indicate the

modulation setting.

Note) Asterisked items arc received but not transmitted.

3.2 BULK DUMPS

The P-100 is capable of transmitting and receiving the following three

types of bulk dumps:

1.System Setup bulk dumps

2.Program change transmit table dumps

3.Program change receive table bulk dumps

< TABLE 1-2 >

MIDI PARAMETER CHANGE TABLE

(PROGRAM CHANGE TRANSMIT TABLE)

$F0, $43, $1n, $2A, $0E, $00, $00, N2, V1, V2, $F7

Notes: n= device number (i.e., transmit/receive table)

N2 = parameter number

= parameter value ( 1 = transmit off)

V2 = parameter value

The P-100 will transmit each of these three bulk dumps. in sequence, when

the MIDI. REVERB. and MODULATION buttons arc pressed

simultaneously. It can receive any one of the three bulk dump types

independently of the others.

The P-100 uses its current transmit channel (Tch) setting as its device

number when transmitting bulk dumps. and its current receive channel

(Rch) setting when receiving them.

For the formats of these bulk dumps. refer to Table 2-l through 2-3 below.