Yamaha P-200 1. , 2., 1.

34
SELECTING SPLIT VOICES
1. Main Voice: Press a [VOICE SELECT] button. When you press the [SPLIT] button to enter Split mode, the voice you were
playing in Single mode (or the main voice you were playing in Dual mode) will
be assigned by default to the main keyboard area.
To change the main voice, simply press any [VOICE SELECT] button, the same
as you would in Single mode.
2.Sub Voice: Hold the [SPLIT] button and press a [VOICE SELECT] button. Note that you can assign the same voice to both main and sub keyboard
areas. This is useful in such cases where you want to use the same voice on
each end of the keyboard, but with different Transpose settings (for details, see
page 37), or at different volume balance levels.
You’ll find it convenient that the procedure for selecting voices is separate from
that for entering and leaving Split mode, since this lets you switch the sub
keyboard area on and off as needed. For example, you can play the main voice
in Single Play mode (or Dual voices) across the entire keyboard during a song’s
verse and chorus, then switch into Split mode to add the sub voice for an
intricate two-part solo, then switch the Split mode off to play remaining verses
and choruses.
ADJUSTING THE BALANCE OF THE SPLIT VOICES
1. Hold the [BALANCE] button and move the [DATA ENTRY] slider. As you move the [DATA ENTRY] slider, the SPLIT BALANCE screen appears.
SPLIT BALANCE $
J0 

Sub Main
INT.EQ
KBD SENS.
PB MW
NAMEPSCS FC
LOCAL
CHANNEL
PC TABLEMIDI FILTER
SYSTEM
PIANO 1 PIANO 2 PIANO 3 PIANO 4 E.PIANO 1 E.PIANO 2 E.PIANO 3 VIBES ORGAN 1 ORGAN 2 STRINGS BASS
ORGAN
COMBINATION
123456789101112
INT.EQ
KBD SENS.
PB MW
NAMEPSCS FC
LOCAL
CHANNEL
PC TABLEMIDI FILTER
SYSTEM
PIANO 1 PIANO 2 PIANO 3 PIANO 4 E.PIANO 1 E.PIANO 2 E.PIANO 3 VIBES ORGAN 1 ORGAN 2 STRINGS BASS
ORGAN
COMBINATION
123456789101112
BALANCE
SPLIT
+
CS
DATA ENTRY
BALANCE
SPLIT +