Accessory CD-ROM Installation Guide

Installing the driver on Windows 98/Me

1 Start the computer.

2 Insert the supplied CD-ROM into the CD- ROM drive. A start window will appear automatically.

3 First, make sure the POWER switch on the instrument is set to OFF, then use a USB cable to connect the USB terminal of the computer to the USB connector of the instrument. When the instrument is turned on, the computer automatically displays the “Add New Hardware Wizard. Otherwise, refer to “Troubleshooting” in the “Accessory CD-ROM Installation Guide” section of the Owner’s Manual.

For Windows Me users, check the radio button to the left of “Automatic search for a better driver (Recommended)” and click [Next]. The system automatically starts searching and installing the driver. Proceed to Step 8. If the system does not detect the driver, select “Specify the location of the driver (Advanced)” and specify the CD-ROM drive’s root directory to install the driver and click [Next]. Execute the installation by following the onscreen instructions and proceed to Step 8.

NOTE

• If you are using Windows Me, skip Step 4–7.

4 Click [Next].

The window enables you to select the search method.

5 Check the radio button to the left of “Search for the best driver for your device. (Recommended)”. Click [Next].

The window enables you to select a location in which to install the driver.

6 Check the “Specify a location” box, click “Browse..”, then specify the root directory of the CD-ROM drive and continue the installation. The CD-ROM drive letter may vary depending on your computer’s configuration.

7 When the system detects the driver on the CD-ROM and is ready for installation, it is shown as a message on the screen. Make sure that the “YAMAHA USB MIDI Driver” is listed, and click [Next]. The system starts the installation.

8 When installation is complete, a message indicating so appears. Click [Finish].

The driver has been installed.

NOTE

•Some computers may take about ten seconds to show this screen after the installation is complete.

Installing the driver on Windows 2000

1 Start the computer and use the “Adminis- trator” account to log into Windows 2000.

2 Select [My Computer] ➔ [Control Panel]

➔[System] ➔ [Hardware] ➔ [Driver Sign- ing] ➔ [File Signature Verification], and check the radio button to the left of “Ignore—Install all files, regardless of file signature” and click [OK].

3 Insert the supplied CD-ROM into the CD- ROM drive. A start window will appear automatically.

4 First, make sure the POWER switch on the MIDI device is set to OFF, then use a USB cable to connect the MIDI device to the computer. After making the connections, turn on the power of the MIDI device. The system automatically launches the Found New Hardware Wizard.

Otherwise, refer to “Troubleshooting” in the “Accessory CD-ROM Installation Guide” section of the Owner’s Manual. Click [Next]. (Some computers may take a while to display the Wizard window.)

5 Select the radio button for “Search for a suitable driver for my device [recom- mended]”, then click [Next].

NOTE

•If the Wizard panel informs you that “The software you are about to install does not contain a Microsoft digital signature”, click [Yes].

6 Check the “CD-ROM drives” check box, deselect all other check boxes, then click [Next].

NOTE

•If the system prompts you to insert the Windows CD-ROM during detection of the drivers, point to the “USBdrv2k_” folder (e.g., D:\USBdrv2k_) and continue the installation.

7 Deselect the “Install one of the other driv- ers”, then click [Next].

8 When the installation is complete, the Wizard displays “Completing the Found New Hardware Wizard”.

Click [Finish]. (Some computers may take a while to display the Wizard window.)

9 Restart the computer.

The USB-MIDI driver installation is complete.

PSR-S500 Owner’s Manual 91